One gallon covers 12 sq.m / 130 sq.ft. with one coat
Surface must be clean and dry
Apply in temperatures above 10° C/50° F
Apply 2 to 3 coats for maximum protection
Use Clean brush /Roller /Spray Gun with Warm Water
ADVANTAGES OF USE
Specifically Formulated to a Super-Hard finish. Smooth or Anti-slip finish.
Resistant to salt, moisture, anti-rust/anti-corrosion, chemicals, acids, extreme to hot or cold temperatures.
Can Be Brushed, Roller or sprayed directly on surface..
No Primer necessary! Apply directly on metal, wood, concrete, asphalt, fiberglass & rubber surfaces .
Fast Drying.Less than 20 minutes. In Warm to Hot Temperatures
High Impact resistant Resists wear to severe cargo impact,
Anti-corrosion -salt water and corrosive chemical acid spills.
Anti-Slip adds safety for applications where anti-slip/anti-shifting is required.
Extremely resistant to WEATHER
Repels WATER.Salt & excellent for WATERPROOFING.
Rust Repair. Crack & Hole Sealer
A non-porous coating that won't crack chip, or peel.
Isolates metal from moisture thus preventing steel rust.
Fluorescent Pigment Available - providing clear visual safety benefits
Inhibitor Corrosion. Aluminum Corrosion. Corrosion Control
Protection & Solution
Anti-Rust. Rust inhibitor
Wood, Metal, Concrete, Coating and Sealer
Available in CUSTOM COLORS with an order of 5 gallons or more !!
Testimonial from Independant Testing Laboratory:
The WHAT A JOB Industrial coating "showed no loss of adhesion, cracking or peeling and no loss of its protective value when bent at 0° F or minus 18° C through 360° F over 1/8 diameter mandrel. It showed no evidence of rusting or blistering or softening. The same tests results were shown when exposed to hydrochloric, nitric and sulfuric acids, as well as immersed in water at 23° C for a continuous 18 hours. The coating exhibited excellent resistance to abrasion, after 136 kg. or 300 pounds of falling sand, there was no visible wear-through. When a 2 lb. steel ball was dropped from 8 feet / 2.5 meter with the impact at the center of a steel plate, coating exhibited firm adhesion outside the impact area. Using a class 5 knife test there was no evidence of flaking or loss of adhesion.